Table of Contents
Advertisement
OPERATING INSTRUCTIONS
POWER OFF
Downloaded from
www.Manualslib.com
Indicating lamp
Main power switch
(42")
(32")
SUB-POWER button
button
POWER ON
button
VOL
RGB 1
RGB 2
MUTE
VOL
AV1
AV2
AV3
AV4
AUTO
PinP
SIZE
RECALL
MENU
OK
ID
ID SET
manuals search engine
Turning Power On and Off
To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press
the SUB POWER button or the ON/OFF or ON button on
the remote control.
To turn the monitor power OFF, press the SUB POWER
button or the ON/OFF or OFF button on the remote
control, and then press the main power switch on the
monitor main unit to OFF.
During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the ON/OFF button on the remote control.
Indicating lamp
Indicating
lamp
Off
Lights red
Lights green
Lights orange
When the indicating lamp lights in orange or the message "No Sync.
Signal", "Power Save" or "Invalid Scan Freq." appears on the
screen, there is something unusual about the status of reception.
See "Power Save Mode" or "Symptoms That Seemingly Appear to be
POWER ON/OFF
Failures."
button
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
• If a power failure occurs while the main unit is running, it would
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit.
Power status
Operating
When the main power switch is set
Off
to OFF.
When the main power switch is
ON, and the OFF button on the
Off
remote control or the SUB POWER
(standby)
button on the underside of the
front of the frame is OFF.
When the main power switch is
ON, and the ON button on the
On
remote control or the SUB POWER
button on the underside of the
front of the frame is ON.
When the main power switch is
ON, and the ON button on the
remote control or the SUB POWER
Off
button on the underside of the
(Power Save)
front of the frame is ON.
However, the state in POWER
SAVE mode
Advertisement
Table of Contents
