Operating Instructions; Turning Power On And Off - Hitachi LCD Monitor User Manual

Hide thumbs Also See for LCD Monitor:
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

Indicating lamp
POWER button
Main power switch
SUB-POWER button

Turning Power On and Off

• To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press the
SUB POWER button of control panel or the POWER button
on the remote control.
• To turn the monitor power OFF, press the SUB POWER
button of control panel or the POWER button on the
remote control, and then press the main power switch on
the monitor main unit to OFF.
• During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the POWER button on the remote
control.
Indicating lamp
Indicating
Power
lamp
status
Off
Off
Off
Lights red
(standby)
Lights green
On
Off
Lights orange
(Power Save)
When the indicating lamp lights in orange or the message "No
Sync. Signal", "Power Save" or "Invalid Scan Freq." appears on
the screen, there is something unusual about the status of
reception. See "Power Save Mode" or "Symptoms That
Seemingly Appear to be Failures."
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out
of use for an extended period of time.
• If a power failure occurs while the main unit is running, it would
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit.
Operating
When the main power switch is set to
OFF.
When the main power switch is ON, and
the POWER button on the remote control
or the SUB POWER button on the upside
of the monitor is OFF.
When the main power switch is ON, and
the POWER button on the remote control
or the SUB POWER button on the upside
of the monitor is ON.
When the main power switch is ON, and
the POWER button on the remote control
or the SUB POWER button on the upside
of the monitor is ON.
However, the state is in POWER SAVE
mode.(RGB 1 and RGB 2 only.)
43
44
45
19

Advertisement

Table of Contents
loading

Table of Contents