Remote Controller; Loading Batteries; Handling The Remote Controller - Hitachi CMP4202U User Manual

Component Names (continued)

Remote controller

POWER OFF button
POWER ON button
MENU button
ENTER button

Loading Batteries

1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load batteries.
• Load two Size AA batteries included observing the correct
polarities.
3) Close the battery cover.
• Replace the battery cover in the direction of the arrow and snap
it back into place.
CAUTIONS
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
MUTE button
SIZE button
PinP button
AUTO button
ID button
VOL
MUTE VOL
AUTO PinP SIZE RECALL
RGB 1 RGB 2 VIDEO 1 VIDEO 2
MENU RETURN
ENTER
ID ID SET

Handling the Remote Controller

Use the remote controller within about 5 m from front of the unit's
remote-control sensor and within 30 degrees on both sides.
With in 30
degrees
About 3m
TIPS
• Do not drop or impact the remote controller.
• Do not splash the remote controller with water or put it on a wet
object to avoid possible failures.
• Before leaving the remote controller out of use for an extended
period of time, remove the batteries from it.
• If the remote controller begins to lack responsiveness, replace
the batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
POWER ON/OFF button
VOLUME UP/DOWN button
RECALL button
RGB/VIDEO buttons
RETURN button
SELECT/ADJUST buttons
ID SET button
With in 30
degrees
About 3m
About 5m
VOL
MUTE VOL
AUTO PinP SIZE RECALL
RGB 1 RGB 2 VIDEO 1 VIDEO 2
MENU RETURN
ENTER
ID ID SET