Operating Instructions; Turning Power On And Off - Hitachi PW2 42PD7A10A User Manual

OPERATING INSTRUCTIONS

Main power switch
SUB-POWER button
POWER button
• To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press
the SUB POWER button of control panel or the POWER
Indicating lamp
button on the remote control.
• To turn the monitor power OFF, press the SUB POWER
button of control panel or the POWER button on the
remote control, and then press the main power switch
on the monitor main unit to OFF.
• During normal use, the main power switch is set in the ON
Indicating lamp
Indicating
Lights green
Lights orange
When the indicating lamp lights in orange or the message "No
Sync. Signal", "Power Save" or "Invalid Scan Freq." appears on the
screen, there is something unusual about the status of reception.
See "Power Save Mode" or "Symptoms That Seemingly Appear to
be Failures."
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
• Turn off the main power switch before leaving the monitor out of
• If a power failure occurs whilst the main unit is running, it would

Turning Power On and Off

position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the POWER button on the remote control.
Power status
lamp
When the main power switch is set to
Off Off
OFF.
When the main power switch is ON, and
the POWER button on the remote
Off
Lights red control or the SUB POWER button on
(standby)
the underside of the front of the frame is
OFF.
When the main power switch is ON, and
the POWER button on the remote
On control or the SUB POWER button on
the underside of the front of the frame is
ON.
When the main power switch is ON, and
the POWER button on the remote
control or the SUB POWER button on
Off
the underside of the front of the frame is
(Power Save)
ON.
However, the state is in POWER SAVE
mode.
45 46 47
intervals. Failures might result from such operation.
use for an extended period of time.
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit.
Operating
21