Cisco PIX 520 - PIX Firewall 520 Online Help Manual page 203

System Properties>Advanced>FixUp>HTTP
The HTTP panel allows you to enable or disable the PIX Firewall to look into the payload of
apply the Adaptive Security Algorithm (ASA). You can specify the port(s) at which the PIX Firewall listens for
HTTP traffic. HTTP FixUp is enabled for port 80 by default.
The following sections are included in this Help topic:
Important Notes
Field Descriptions
Disabling HTTP FixUp
Enabling HTTP FixUp
Changing the HTTP FixUp Port Number
Resetting to Last Applied Settings
Important Notes
For more information about the protocols used in the FixUp panels, refer to the
Cisco Secure PIX Firewall Version
Field Descriptions
The HTTP panel displays the following fields:
HTTP table
Low Port—Displays the port number or lower port number range for the HTTP fixups.
High Port—Displays the upper port number range (if applicable) for the HTTP fixups.
Add—Copies the new entry into the HTTP table.
Low port—Allows you to enter a port number or lower port number range for addition to the HTTP table.
High port (optional)— Allows you to enter an upper port number range for addition to the HTTP table.
Delete—Deletes the highlighted row from the HTTP table.
Note: If you disable HTTP FixUp, the filter url
Apply to PIX—Sends changes made in PDM to the PIX Firewall unit and applies them to the running
configuration.
Reset—Discards changes and reverts the panel to the information displayed when it was opened or the last
x.x.
CLI
Configuration Guide for the
command does not work.
HTTP traffic and