Cisco PIX 520 - PIX Firewall 520 Online Help Manual page 143

Editing Hosts and Networks
Follow these steps to edit the basic identification information for the host or network:
1. Select the host or network you want to modify and click Edit on the Hosts/Networks tab.
The Edit host/network dialog box appears.
2. To modify the address used to reach the host or network, enter the address in the IP Address box.
3. To modify the network mask value that corresponds to the network or host that you are defining, click the
desired value in the Mask list.
If you are defining a host, you must click the 255.255.255.255 value.
4. If the selected interface does not correspond to the interface from which the host or network is directly
reachable, click the correct interface name in the Interface list.
By default, this value is the interface selected on the Hosts/Networks tab.
5. To modify the name used when referencing this host or network within access or translation rules, enter the
name in the Name (Recommended) box.
While this value is optional, it is recommended.
6. To retain your changes and close the Edit host/network dialog box, click OK.
7. Click Apply to PIX to activate your changes on the PIX Firewall.
8. Use the File menu to write a copy the running configuration to Flash, a
PIX Firewall unit. See Notes on Applying Configuration Changes.
Copyright © 2001
TFTP
Cisco Systems, Inc.
server, or a failover standby