3.11
Setting Up System Parameters (Menu #6)
This menu gives access to the Setup Menu to set up and edit System
Parameters as well as the IRD Details menu (see Table 3.28).
Table 3.27: Setting Up a System
Step
1
2
3
4
5
6
7
8
9
10
11
Table 3.28: Viewing the IRD Details Menu
Step
1
2
3
4
5
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.1
Action
Go to Menu #6.
Scroll down to Menu #6.1 and edit the
Operating Mode (FRONT PANEL, SERIAL
REMOTE, DIRECTOR NCP or NETWORK
(SNMP). Press Save.
Scroll down to Menu #6.1.1 and edit the LCD
Contrast (LOW, MEDIUM or HIGH). Press
Save.
Scroll down to Menu #6.1.2 and edit the
SERIAL REMOTE PROTOCOL mode
(RS232 TTV, RS232 ALTEIA or RS485
ALTEIA)
Scroll down to Menu #6.1.3 and edit the IP
Address. Press Save.
Scroll down to Menu #6.1.4 and edit the
Subnet Mask. Press Save.
Scroll down to Menu #6.1.5 and edit the
Gateway address. Press Save.
Scroll down to Menu #6.1.6 and edit the
Restore system defaults
(ACTIVATE/DEACTIVATE). Press Save.
Scroll down to Menu #6.1.7 and edit the
Service Hunt Mode (ENABLED or
DISABLED). Press Save.
Scroll down to Menu #6.1.8 and edit the Input Edits the Input Stream SI Type.
Stream SI Type (AUTO, FORCED ATSC or
FORCED DVB). Press Save.
Scroll down to Menu #6.1.7 and enter a
Customisation Key. Press Save.
Action
Go to Menu #6.2.
Scroll down to Menu #6.2.1.
Scroll down to Menu #6.2.2.
Scroll down to Menu #6.2.3.
Scroll down to Menu #6.2.4.
Operating the Equipment Locally
Result
Accesses the System menu.
Edits the Operating Mode menu.
Edits the LCD Contrast.
Select the interface needed for serial remote control.
Edits the IP Address.
Edits the Subnet Mask.
Edits the Gateway address.
Edits the Restore System Defaults menu.
Edits the Service Hunt Mode menu.
Edits the Customisation Key menu.
Result
Accesses the IRD Details Menu and displays the Software Version.
Displays the Firmware Version.
Displays the Hardware Version.
Displays the PLD Version.
Displays the Electronic Serial Number.
Page 3-21