TANDBERG TT1260 Reference Manual page 60

Operating the Equipment Locally
·
Burst mode in = > burst mode out.
3.10 Setting Up the Alarms (Menu #5)
Menu #5 allows a selection of Alarms to be edited.
Table 3.26: Setting up the Alarms
Step
1
2
3
4
5
6
Page 3-20
Action
Go to Menu #5.
Scroll down to Menu #5.1 and edit the BIT
ERROR RATE range (9.9 E-1 to 1.0 E-8) and
status (NO ALARM, SET ALARM ONLY, SET
ALARM AND RELAY 1, SET ALARM AND
RELAY 2, SET ALARM AND RELAY 3, SET
ALARM AND RELAY 4, SET ALARM AND
RELAY 5, SET ALARM AND RELAY 6, SET
RELAY 1 ONLY, SET RELAY 2 ONLY, SET
RELAY 3 ONLY, SET RELAY 4 ONLY, SET
RELAY 5 ONLY, or SET RELAY 6 ONLY).
Press Save.
NOTE...
This menu is only available with TT1260 Receivers. Decoders will supply the Transport
Stream alarm first.
Scroll down to Menu #5.2 and edit the
TRANSPORT STREAM menu (NO ALARM,
SET ALARM ONLY, SET ALARM AND
RELAY 1 – 6, SET RELAY 1 – 6 ONLY).
Press Save.
Scroll down to Menu #5.3 and edit the VIDEO Edits the Video alarms menu.
menu (NO ALARM, SET ALARM ONLY, SET
ALARM AND RELAY 1 – 6, SET RELAY 1 – 6
ONLY). Press Save.
Scroll down to Menu #5.4 and edit the
AUDIO 1 menu (NO ALARM, SET ALARM
ONLY, SET ALARM AND RELAY 1 – 6, SET
RELAY 1 – 6 ONLY). Press Save.
Scroll down to Menu #5.5 and edit the
AUDIO 2 menu (NO ALARM, SET ALARM
ONLY, SET ALARM AND RELAY 1 – 6, SET
RELAY 1 – 6 ONLY). Press Save.
Result
Accesses the Alarms menu.
Edits the BER alarms menu.
Edits the Transport Stream alarms menu.
Edits the Audio 1 alarms menu.
Edits the Audio 2 alarms menu.
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.1