Table of Contents
Advertisement
LAN Phone 101 User Manual Guide
Note: LCD Panel of LAN Phone 101 is operated manually by moving or on the keypad.
Press OK to enter separate configuration menu. Press C to go back to the main menu.
2.LCD Configuration
User can set the following 10 configurations manually by operating the commands displayed on
LCD.
Note: Any configurations that have made for the LAN Phone 101, user has to do Reboot in the
selection 1→5 "Reboot".
1. System Configuration (mandatory, protected by password)
Please Enter Password:
User must key in password to enter this menu, selections under this command are all
important ones, which can only be configured by administrators.
Note: Password to enter System Configuration:
H.323 token password (please refer to item 9), default value is x
1. Connect Configuration
There are ten sub-configurations included in Connect Configuration. It is necessary
for user to set it in order to run the LAN Phone 101 correctly.
In addition, user has to prepare one valid IP Address to meet your network
environment. (Global public IP Address or Virtual IP Address)
(1) IP address
In this configuration mode, user presses the prepared IP Address on the LAN
Phone keypad. Please input IP address as format: xxx.xxx.xxx.xxx.
(2) Subnet Mask:
User has to press the subnet mask IP Address on the LAN Phone keypad.
(3) Gateway
User has to press the default gateway IP which meets IP Address on the LAN
Phone keypad.
(4) Primary DNS
User can set IP address of Domain Name Server, then for GateKeeper and Phone
book can enter URL address or IP address. Please refer to 3.9 [pbook] and 3.12
[h323] command.
(5) Secondary DNS
User can set IP address of secondary DNS, once primary DNS cannot work
normally, LAN Phone can refer to secondary DNS.
Copyright (c) 2002 WellTech Computer Corporation
13
LAN Phone Ver. 113/503(Normal and PPPoE)
Document Ver. 1.8
Advertisement
Table of Contents
