Table of Contents
Advertisement
LAN Phone 101 User Manual Guide
3.
User Line Number/Name (mandatory)
4.
Ring Configuration
5.
Indicate Forward Type
6.
Message Box
7.
Phone Address Book
8.
Firmware Upgrade
9.
Hardware Test
10. Reboot
Note: 1. LCD Panel of LAN Phone 101 is operated manually by moving or on the keypad.
Press OK to enter separate configuration menu. Press C to go back to the main menu.
2.LCD Configuration
User can set the following 10 configurations manually by operating the commands displayed on
LCD.
Note: Any configurations that have made for the LAN Phone 101, user has to do Reboot in the
selection 10 "Reboot".
1. Quick Setup(mandatory)
If it is the first time for user to configure LAN Phone 101 , suggest use this command to
complete overall configuration .After finish each step please press ok button , system will save
configuration and jump to next step.
1.
Choose Connect Type:
There are three types to select for LAN Phone 101 to connect to the other devices.
They are GK, P2P and FXO. The default mode should be in GK mode. When user
would like to connect via P2P mode, the LAN Phone 101 must change as well. Move
the "~" symbol by press or on the keypad to select one type .
FXO mode is not available in this version yet .
2.
Please Enter IP Phone IP:
In this configuration mode, user presses the prepared IP Address on the LAN Phone
keypad. Please input IP address as format :xxx.xxx.xxx.xxx.
3.
Please Enter Subnet Mask IP:
User has to press the subnet mask which meets IP Address on the LAN Phone
keypad.
4.
Please Enter Gateway IP:
Copyright (c) 2002 WellTech Computer Corporation
12
Document Ver. 1.5
LAN Phone Ver 109
Release 2002/06/07
Advertisement
Table of Contents
