Pppoe] Command - WELLTECH LAN PHONE 101 H.323 - VERSION 113 & 503 Manual

LAN Phone 101 User Manual Guide

10.[pppoe] command

Note: Firmware of LAN Phone are separate into normal version and PPPoE version.
1. This command can only see in PPPoE version, in normal version PPPoE function is not
implemented.
2. In PPPoE version has no TOS command.
1. -print: display system overall information and configuration. IF LAN Phone has already
connected to PPPoE server, user can see IP address and related information with this
command.
2. -dev: to enable or disable PPPoE function.(pppoe –dev 0/1)
3. –open: to open PPPoE connection(If LAN Phone is not in PPPoE connection, user can try to
connect with pppoe -open)
4. –close: to close PPPoE connection(If LAN Phone is in PPPoE connection, user can
disconnect with pppoe -close)
5. –id: to set PPPoE connection user name
6. –pwd: to set PPPoE connection password
7. –reboot: If user enable this function, after PPPoE being disconnected, LAN Phone will
automatically reboot to re-connect, and after reboot, if LAN Phone still can't get contact
with server, LAN Phone will keep trying to connect. On the other hand, if user disable this
function, LAN Phone won't reboot and keep trying to connect.(pppoe –reboot 0/1)
Copyright (c) 2002 WellTech Computer Corporation
24
LAN Phone Ver. 113/503(Normal and PPPoE)
Document Ver. 1.8