LAN Phone 101 User Manual Guide
Chapter 3 Advanced Configurations via Telnet
After initializing the LAN Phone 101 IP Address setting (please refer to LCD Configuration:
1.Connect Configuration), user can enter into configuration mode via telnet. There are 18
commands listed below.
Note:
1.After user enter LAN Phone configuration via telnet, please use login : "root",
password : "press enter" to enter command line.
2.Each command user must key-in with lower case, but contents of configurations such as
h.323 alias or user name etc, user can set as capital case.
3.User who changes any configuration needs to do the commit command then reboot
command.
1. [help] command
Type help or man or ? to display all the command lists. The following figure is shown all
commands of LAN Phone 101.
Copyright (c) 2002 WellTech Computer Corporation
19
LAN Phone Ver. 113/503(Normal and PPPoE)
Document Ver. 1.8