LAN Phone 101 User Manual Guide
16. [support] command
1.-print : display current SUPPORT values configurations.
2.-fstart: enable or disable fast start (support –fstart 0/1 , 0 for disable and 1 for enable.)
Note: When fast start function is enabled, if user wants to send DTMF message after
connection, LAN Phone will send out Q.931 message. (Please refer to 11.sysconf –keypad
command, which can only set keypad as q.931 message at this time)
3.-tunnel: enable or disable H.245 tunnel function.(support –tunnel 0/1 , 0 for disable and 1
for enable)
4.-h245fs:set if open H.245 separate channel after fast start or not. (support –h245fs 0/1 , 0
for open and 1 for not.)
17. [bureau] command
Type bureau can display commands below.
Copyright (c) 2002 WellTech Computer Corporation
31
LAN Phone Ver. 113/503(Normal and PPPoE)
Document Ver. 1.8