Table of Contents
Advertisement
LAN Phone 101 User Manual Guide
Note: LCD Panel of LAN Phone 101 is operated manually by moving or on the keypad.
Press OK to enter separate configuration menu. Press C to go back to the main menu.
2.LCD Configuration
User can set the following 10 configurations manually by operating the commands displayed on
LCD.
Note: Any configurations that have made for the LAN Phone 101, user has to do Reboot in the
selection 1→5 "Reboot".
1. System Configuration (mandatory, protected by password)
Please Enter Password:
User must key in password to enter this menu, selections under this command are all
important ones, which can only be configured by administrators.
Note: Password to enter System Configuration:
(1) H.323 token password (please refer to item 9), default value is X
(2) If user forget password, also can enter by MAC address (please see label under
LAN Phone in format of "0001a800xxx")
1. Connect Configuration
There are ten sub-configurations included in Connect Configuration. It is necessary
for user to set it in order to run the LAN Phone 101 correctly.
In addition, user has to prepare one valid IP Address to meet your network
environment. (Global public IP Address or Virtual IP Address)
(1) IP address
In this configuration mode, user presses the prepared IP Address on the LAN
Phone keypad. Please input IP address as format: xxx.xxx.xxx.xxx.
(2) Subnet Mask:
User has to press the subnet mask IP Address on the LAN Phone keypad.
(3) Gateway
User has to press the default gateway IP which meets IP Address on the LAN
Phone keypad.
(4) GateKeeper
User has to offer one available GateKeeper server IP Address and set this IP
Address on the LAN Phone keypad.
(5) Second GateKeeper
Copyright (c) 2002 WellTech Computer Corporation
12
LAN Phone Ver. 112/502(Normal and PPPoE)
Document Ver. 1.7
Advertisement
Table of Contents
