Dc Gear Holder Assy - Brother HL 2060 - B/W Laser Printer Service Manual

(3) Open the transfer base hook and take off the left bearing (white) from the hook
( A ). Lift the left side ( B ), slide it to the left ( C ) and take off the roller shaft from
the right bearing (black) ( D ).
(4) Remove the transfer roller ASSY.
Caution: Do not touch the sponge rubber roller when replacing the transfer roller (the
roller with hand grease or clasped too strongly may result in poor printing
quality).
A
Transfer roller ASSY
1.30

DC Gear Holder ASSY

(1) Remove the DC motor connector, then remove the Paper delivery holder spring.
(2) Loosen the 4 screws and remove the DC gear unit from the chassis.
(3) Remove the Paper delivery gear ASSY, the gears, the Gear 48 spring, and the
washer.
(4) Loosen the 3 screws and remove the DC motor ASSY from the gear holder.
DC gear unit
Remote switch
Figure 4.59
B
D
Figure 4.58
Paper delivery
holder spring
4 screws
Gear 22/55
PS switch wire
DC motor ASSY
3 Hooks
Transfer base ASSY
C
Gear 21
Gear 28
Connector
IV-28
Paper delivery gear ASSY
Gear 48
Gear 48 spring
Washer
Gear 24/72
Gear 39
3 screws
DC gear holder ASSY
Figure 4.60
Gear 20/50