Laser Unit - Brother HL 2060 - B/W Laser Printer Service Manual

(6) Remove 8 screws and the Main PCB ASSY.
Main PCB ASSY
1.10

Laser Unit

(1) Unplug the LSR flat cable connector (6P), and LSR harness connector (14P).
(2) Remove the beam from the chassis by loosening the screws.
(3) Remove the Laser unit from the chassis by loosening the screws.
Caution: Do not disassemble the Laser unit, it can be only adjusted at the factory only.
LSR harness 14P
Polygon control PCB
Release the hook to loosen
the cable tie.
Figure 4.18
8 screws
Figure 4.17
LSR flat cable 6P connector
IV-11
Laser unit
Screws
Figure 4.19
Screws
Beam