Display Circuit; Outline; Operation - Brother HL 2060 - B/W Laser Printer Service Manual

3.

DISPLAY CIRCUIT

3.1

Outline

The control panel of this printer has four LED lamps, one LCD display, and eight
switches.
The control panel is connected to the Main PCB and its functions are as follows:
(1) The LCD shows the printer status and error message in alpha-numeric characters.
(2) The LED lamps indicate the operating conditions of the printer.
(3) The printing mode and LCD brightness can be changed by switches.
LCD
3.2

Operation

Indicators on the control panel (LED lamps and LCD) are controlled by the video
controller circuit.
All the switch signals are input to the video controller circuit.
Signals Descriptions:
LED1 - LED4
PAD4 - PAD7 LCD control signal.
LCDRS
LCDE
SW1 - SW8
PAD4-PAD7
LCDE, LCDRS
LED4 (ONLINE)
LED2 (DATA)
LED5 (ONLINE)
SW1 (FORMFEED)
SW4 (SEL)
SW2 (UP)
SW5 (FONT)
SW3 (DOWN)
SW6 (SET)
LED1 (READY)
LED3 (ALARM)
SW8 (CONTINUE)
SW7 (MODE)
Figure 3.8 Display Circuit
On-off control for the respective LED lamps.
Illuminating when Low and extinguished when High.
A signal to distinguish PAD4 - PAD7 into command and data.
A signal to start the operation.
Input signals from the switches.
Going Low when each switch is pressed.
III-9
Main PCB