Dc Gear Holder Assy; Ps Switch Wire, Remote Switch - Brother 1660E Service Manual

1.31 DC Gear Holder Assy

(1) Remove the DC motor connector, then remove the paper delivery holder spring.
(2) Loosen the 4 screws and remove the DC gear unit from the body.
(3) Remove the paper delivery gear assy, the gears, the gear 48 spring, and the washer.
(4) Loosen the 3 screws and remove the DC motor assy from the gear holder.
DC gear unit
Remote switch

1.32 PS Switch Wire, Remote Switch

(1) Pull out the PS switch wire from the remote switch and the switch attachment.
Lift slightly the wires when pulling them out. This is in order to release the chassis caught at 2
places.
(2) Remove the remote switch from the chassis.
Remote switch
Paper delivery
holder spring
4 screws
Gear 22/55
PS switch wire
DC motor assy
Figure 4.58
PS switch wire
Figure 4.60
Paper delivery gear assy
Gear 21
Gear 28
DC gear holder assy
Connector
Switch attachment
Remote switch
IV - 23
Gear 48
Gear 48 spring
Washer
Gear 24/72
Gear 39
3 screws
Figure 4.59
Figure 4.61
Gear 20/50
Chassis