Throttle Housing Disassembly; Steering System: Removal Of Kingpin And Tie-Rod - E-TON VIPER 50 ST Service Manual

Aligning the split line of the throttle housing
and holder with the punch mark. Tighten the screw
securely

8.4 THROTTLE HOUSING DISASSEMBLY

Unscrew the screws on the throttle housing cover.
Remove throttle housing cover and gasket. Disconnect
throttle cable from the throttle arm
and remove from the throttle housing.
Assembly is in the reverse order of
disassembly.
8.5 STEERING SYSTEM
Removal of Kingpin and Tie-rod
Remove the front wheels and brakes plates.
Remove the four self-lock nuts from the tie-rod ball joints
and take off the two tie-rods.
Remove the cotter pin on the kingpin.
Unscrew the bolt and remove the kingpin.