Embedded Cli (Telnet); Configuring The Embedded Cli (Telnet) Feature; Using The Embedded Cli (Telnet) Feature - Intel SC5300AF2 - Server Platform - 0 MB RAM Installation And User Manual

Embedded CLI (Telnet)

Configuring the Embedded CLI (Telnet) Feature

Run the Server Configuration Wizard (SCW) on the Intel Server Deployment Toolkit CD to
configure the Embedded CLI Telnet Server.
The SCW allows you to:
•
Enable the Telnet Server in firmware
•
Configure the Telnet port number

Using the Embedded CLI (Telnet) Feature

The firmware on the Advanced Edition module includes a telnet server. The telnet server provides
you with both in-band and out-of-band monitoring and control of the server by using Intel's
proprietary Command Line Interface (CLI) syntax called Common CLI (CCLI). The telnet server
also allows you to establish a Serial Over LAN (SOL) session.
To use the embedded CLI feature, do the following:
1. Connect to the Telnet server.
For example, to Telnet to a server at IP address 222.222.222.36 from the command prompt,
type the following:
Telnet 222.222.222.36
2. Log-in to the server. The Telnet server will ask for the BMC user name and password for
LAN channel 3 (this is the NIC attached to the Advanced Edition module). (Use the SCW to
configure the user names and passwords.)
The server responds with the CLI prompt:
CLI>
3. Type a CLI command (the CLI syntax is listed in
CLI>health
The server return codes and responses are listed in
NOTE
The CLI syntax for the embedded Telnet server is slightly different than the syntax defined in the
IPMI 1.5 specification for terminal mode CLI.
Intel® Management Module Installation and User's Guide
Appendix A on page 26). For example:
Appendix A on page 26.
21