Using The Scsiselect Utility Program (Some Models); Starting The Scsiselect Utility Program; Scsiselect Menu Choices - IBM 6219 - IntelliStation M - Pro Hardware Maintenance Manual

2. Select System Board Ethernet PXE/DHCP and use the Right Arrow (→) key to
3. Select Save Settings and press Enter.

Using the SCSISelect Utility program (some models)

SCSISelect is a menu-driven configuration utility program that you can use for
models that come with a SCSI adapter. You can use this program to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
v Perform a low-level format on a SCSI hard disk
The following sections provide instructions for starting the SCSISelect Utility
program and descriptions of the menu choices.

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect utility program:
1. Turn on the computer.
2. When the <<< Press <CTRL><A> for SCSISelect Utility! >>> prompt appears,
3. When the question Would you like to configure the host adapter or run
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected

SCSISelect menu choices

The following choices appear on the SCSISelect Utility menu:
v Configure/View Host Adapter Settings
22
IBM IntelliStation M Pro Type 6219: Hardware Maintenance Manual
set it to Enabled.
press Ctrl+A.
Note: If an administrator password has been set, you are prompted to type the
password to start the SCSISelect Utility program.
the SCSI disk utility? appears, make your selection and press Enter.
v Press Esc to return to the previous menu.
v Press the F5 key to switch between color and monochrome modes (if your
monitor permits).
items, and press Enter.
Select this choice to view or change the SCSI controller settings. To reset the
SCSI controller to its default values, press F6; then, follow the instructions that
appear on the screen.