No-Beep Symptoms; Diagnostic Error Codes - IBM 6219 - IntelliStation M - Pro Hardware Maintenance Manual

No-beep symptoms

No-beep symptom
No beep occurs during POST.

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Error code/symptom
001-XXX-000
(Failed core tests)
001-XXX-001
(Failed core tests)
001-250-000
(Failed system board ECC)
001-250-001
(Failed system board ECC)
005-XXX-000
(Failed video test)
011-XXX-000
(Failed COM1 serial port test)
011-XXX-001
(Failed COM2 serial port test)
014-XXX-000
(Failed parallel port test)
015-XXX-001
(USB interface not found, board damaged)
015-XXX-198
(USB device connected during USB test.)
020-XXX-000
(Failed PCI interface test.)
030-XXX-00N
(Failed SCSI interface test.)
FRU/action
v System board
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
FRU/action
v System board
v System board
v System board
v System board
1. Video adapter (if installed)
2. System board
1. Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
1. Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
v System board
1. System board
1. Remove USB devices from USB1, USB2, USB3 and USB4; then,
run the USB interface test again.
2. System board.
v System board
v If N=0, system board; if N>0, SCSI adapter in slot N.
81
Symptom-to-FRU index