Setting The Password Check Jumper (Jp1); Enabling Broadcom Netxtreme Gigabit Ethernet Boot Agent - IBM 6219 - IntelliStation M - Pro Hardware Maintenance Manual

Setting the password check jumper (JP1)

The following illustration shows the location of the password check jumper (JP1) on
the system board.
Note: The default setting is enabled (2-3); however, some early system may default
Password check
jumper
Complete the following steps to set the password check jumper (JP1):
1. Review "Important safety information" on page iii.
2. Turn off the computer and peripheral devices.
3. Disconnect all external cables and power cords; then, remove the cover. See
4. Connect the computer to a power source, keyboard, monitor, and mouse.
5. Turn on the computer.

Enabling Broadcom NetXtreme Gigabit Ethernet Boot Agent

The Broadcom NetXtreme Gigabit Ethernet Boot Agent is part of the BIOS code
that comes with your computer. You can enable the Broadcom NetXtreme Gigabit
Ethernet Boot Agent from the Configuration/Setup Utility program. You can use the
Broadcom NetXtreme Gigabit Ethernet Boot Agent to configure the network as a
startable device, and you can customize where the network startup option appears
in your startup sequence.
Complete the following steps to enable Broadcom NetXtreme Gigabit Ethernet Boot
Agent:
1. From the Configuration/Setup Utility main menu, select Devices and I/O Ports
to disable (1-2).
(JP1)
Boot block
jumper (JP2)
"Turning off the computer" on page 14 for instructions.
v To disable password checking, set JP1 to disable (1-2).
v To enable password checking, set JP1 to (2-3).
and press Enter.
CMOS
clear jumper (JP3)
21
Configuration