Intel SBX82 - Server Compute Blade Installation And User Manual page 81

Table 7. Light path diagnostics
LED
None An error has occurred and cannot
be isolated, or the service processor
has failed. The error is not
represented by a light path
diagnostic LED.
DIMM x error A memory error has occurred.
Processor x The processor has failed.
error
Temperature The system temperature has
error exceeded a threshold level.
System board The system board has failed.
error
NMI error The system board has failed.
Processor The processors do not match.
mismatch
Problem
Check the system error log in the management
module for more information about the error.
Replace the failing DIMM, indicated by the lit DIMM
failure LED.
Multiple DIMM LEDs do not necessarily indicate
multiple DIMM failures. If more than one DIMM LED
is lit, reseat or replace one DIMM at a time until the
error goes away. Check the system error log in the
management module for information about the
error.
Make sure that the processor that is indicated by
the lit LED is installed correctly (see "Installing an
additional processor" on page 25 for installation
instructions).
•
•
Replace the blade server cover, reinsert the blade
server in the SBCE unit, and then restart the server.
1.
2.
Make sure that processors 1 and 2 have the same
cache size and type and the same clock speed.
Internal and external clock frequencies must be
identical.
Action
Determine whether a blower on the SBCE unit
has failed. If it has, replace the fan.
Make sure that the room temperature is not too
high (see "Features and specifications" on
page 4 for temperature information).
Replace the blade server cover, reinsert the
blade server in the SBCE unit, and then restart
the server.
Check the system error log in the management
module for information about the error.
67