Bridge Specifications - Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual

Chapter 1 Overview

Bridge Specifications

Table 1-1 lists specifications for the bridge.
Table 1-1
Category
Physical
Radio
OL-1412-01
Bridge Specifications
Size
Status indicators
Connectors
Voltage range
Operating temperature range
Weight
Power output
Frequency
Range ( with 2.2 dBi antenna)
Modulation
Data rates
Antenna
Compliance
Specification
6.25 in. (15.9 cm) W x 6.42 in. (16.3 cm) D x 1.31 in. (3.3 cm) H
Three indicators on the top panel: Ethernet traffic, status, and
radio traffic
On the back panel: An RJ-45 jack for 10/100 Ethernet
connections; a 9-pin serial connector; and two reverse-TNC
antenna connectors
(24 –10%) VDC to (60 –0%) VDC, nominal 48 VDC
o o
–4 to 131 F (–20 to 55 C)
o o
32 to 104 F (0 to 40 C) for power injectors
1.43 lbs (0.64 kg)
100, 50, 30, 20, 5, or 1 mW (depending on the regulatory domain
in which the bridge is installed)
2.400 to 2.497 GHz (Depending on the regulatory domain in which
the bridge is installed)
Indoor:
150 ft at 11 Mbps
350 ft at 1 Mbps
Outdoor:
800 ft at 11 Mbps
2000 ft at 1 Mbps
Direct Sequence Spread Spectrum
1, 2, 5.5, and 11 Mbps
Two reverse-TNC connectors (antennas are sold separately).
Operates license-free under FCC Part 15 and complies as a
Class B computing device. Complies with DOC regulations.
Complies with the following: ETS 300.328, FTZ 2100, MPT
1349, FCC Part 15.107 and 15.109 Class B, ICES-003 Class B
(Canada), CISPR 22 Class B, AS/NZS 3548 Class B, VCCI
Class B, EN 50082-1, UL1950, CSA 22.2 No. 950, EN 60950,
IEC 60950, VCCI, and others (see Appendix B).
350 series bridge complies with UL 2043 for products installed
in air handling spaces, such as above suspended ceilings.
Cisco Aironet 350 Series Bridge Hardware Installation Guide
Bridge Specifications
1-7