Cautions And Warnings - Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual

Cautions and Warnings

Cautions and Warnings
Translated versions of the following safety warnings are provided in Appendix A, "Translated Safety
Warnings."
The FCC, with its action in ET Docket 96-8, has adopted a safety standard for human exposure to
Note
radiated frequency (RF) electromagnetic energy emitted by FCC-certified equipment. Cisco Aironet
products meet the uncontrolled environmental limits found in OET-65 and ANSI C95.1, 1991. Proper
operation of this radio device according to the instructions in this publication will result in user exposure
substantially below the FCC recommended limits.
Cisco Aironet power injectors are designed for use with 350 series access points and bridges only. Using
Caution
the power injector with other Ethernet-ready devices can damage the equipment.
The operational voltage range for Cisco Aironet 350 series access points and bridges is 24 to 60 VDC.
Caution
Higher voltage can damage the equipment.
Do not operate your wireless network device near unshielded blasting caps or in an explosive
Warning
environment unless the device has been modified to be especially qualified for such use.
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning Read the installation instructions before you connect the system to its power source.
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the
phase conductors (all current-carrying conductors).
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
Cisco Aironet 350 Series Bridge Hardware Installation Guide
2-2
Chapter 2 Installation
OL-1412-01