IBM 88371RU Maintenance And Troubleshooting Manual page 33

Slot 2 adapter cover
Figure 13. Slot 2 connectors and latches
3. Lift up and remove the slot 2 adapter cover. The slot 2 riser card is attached to
the adapter cover, and you remove the riser card along with the adapter cover.
Figure 14 identifies the components that are referred to in this procedure.
Figure 14. Riser card and adapter cover removal
4. Remove the expansion-slot cover for slot 2, which is also attached to the slot 2
adapter cover, to provide an opening for the adapter.
Hold the adapter cover so that the expansion-slot cover faces you. Slide the
expansion slot cover first to the left, and then in and toward the inside of the
adapter cover. You can now remove the expansion slot 2 cover. Store the
cover in a place safe.
Notes:
a. You might have to use a coin or screwdriver to slide the expansion slot
cover to the left.
Access hole to
retention latch
Riser card
Riser card
retention latches
Chapter 3. Customer replaceable units
23