Chapter 2. Configuring The Server; Configuration Programs; Starting The Configuration/Setup Utility Program - IBM 88371RU Maintenance And Troubleshooting Manual

Chapter 2. Configuring the server

The ServerGuide
installation tools that are specifically designed for an IBM server. Use this CD during
the initial installation of the server to configure basic hardware features and to
simplify the operating-system installation.

Configuration programs

In addition to the ServerGuide Setup and Installation CD, you can use the following
configuration programs to customize the server hardware:
v Configuration/Setup utility program
v Ethernet controller configuration
v BMC firmware update utility program
v RAID configuration programs
v SCSISelect utility program
v Using the ServeRaid configuration programs
For more information about these programs, see "Configuring the server" in the
User's Guide on the IBM xSeries Documentation CD.

Starting the Configuration/Setup Utility program

Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the server and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup appears, press F1. If
3. Follow the instructions on the screen.
© Copyright IBM Corp. 2002, 2007
™
Setup and Installation CD provides software setup tools and
– LSI Logic configuration utility program
– ServeRAID Manager
an administrator password has been set, you must type the administrator
password to access the full Configuration/Setup Utility menu.
13