Installing The Cover - IBM 88371RU Maintenance And Troubleshooting Manual

Installing the cover

Complete the following steps to install the server cover:
1. Position the internal cables so that they do not interfere with the cover
2. Position the cover on top of the server and slide it forward.
3. Press down on the cover release latch until the cover properly engages all the
Figure 10. Cover installation
4. Close the fan doors.
5. Install the server in the rack. See the Rack Installation Instructions that come
installation.
Important: Before sliding the cover forward, make sure that all the tabs on both
the front, rear, and side of the cover engage the chassis correctly. If
all the tabs do not engage the chassis correctly, it will be very
difficult to remove the cover later.
inset tabs on the server.
Fan door
with the server for details.
Cover release latch
Fan door
Chapter 3. Customer replaceable units
19