Improving Receiver Control; Changing The Address - Dish Network Solo 381 User Manual

Chapter 9

Improving Receiver Control

I R
MPROVING ECEIVER
These instructions help you improve your remote control settings to best operate your satellite
receiver.

Changing the Address

Because UHF signals travel long distances and go through walls, a neighbor's remote may control
your receiver by mistake. To keep this from happening, you can change the remote address.
1
Press SYSTEM INFO on the receiver's front panel. The System Information screen displays and
shows the Remote Address.
Write down the address shown:
2
Press and hold SAT on your remote control for about three seconds, until all of the mode buttons
light up, and then let go of SAT.
3
Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote in step
1.
4
Press POUND (#). If you entered the address correctly, SAT will flash three times.
Write down the number you entered:
5
Press RECORD. Make sure the Remote Address you see on the System Information screen is the
same as the one you entered in step 3. If it isn't, the remote cannot control the receiver.
6
Press SELECT to close the System Information screen.
46
C
ONTROL