Table of Contents
Advertisement
Table 115: Virtual Network Configuration Details
Option
Virtual Network >Home Agent Address
Name
Comment
Registration Lifetime
Timestamp Tolerance
Starting Ip Address
Ending Ip Address
Revocation Required
Configuring the Peer (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Chapter 13: Configuring Services for J Series Services Routers and SRX Series Services Gateways
Add or modify the settings as specified in Table 115 on page 173.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the virtual network options.
Function
Specifies the loopback IP address of the home
agent.
Specifies the comment for the home agent.
Specifies the maximum registration lifetime.
Specifies the maximum timestamp tolerance.
Specifies the starting IP address of the pool.
Specifies the ending IP address of the pool.
Enables registration revocation.
NOTE: This is a mandatory field.
This section provides information on configuring a peer for Mobile IP.
To configure Peer:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the peer feature.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Peer.
Enter a comment in the Peer workspace that describes the peer.
4.
Add or modify the settings as specified in Table 116 on page 174.
5.
Click one:
6.
OK—Saves the changes.
Your Action
Enter the IP address.
Enter a comment.
Set the maximum registration life time.
Range: 7 through 65535.
Set the maximum timestamp tolerance.
Range: 1 through 255.
Enter the IP address.
Enter the IP address.
Select the check box.
173
Advertisement
Table of Contents
