Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV Manual page 350

Configuring J Series Services Routers and SRX Series Services Gateways Guide
326
To configure the simple filters for inet in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Firewall > Family > Inet.
3.
Select Simple Filters.
4.
Add or modify settings as specified in Table 204 on page 326.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 204: Simple Filter Details
Task
Configure simple filter.
Define a term.
Your Action
1. Click Simple Filter next to Inet.
2. Click Add new entry next to Simple Filter.
3. In the Name box, enter the name that identifies the simple
filter.
1. Click Term next to simple-filter.
2. Click Add new entry next to Term.
3. Expand Term.
4. In the Name box, enter the name that identifies the term.
5. In the Comment box, enter the comment.
6. Expand From.
7. From the listed protocol-independent match conditions, select
the filters defined for the Inet family type.
The protocol-independent match conditions are Destination
Address, Destination port, Forwarding Class, Protocol, Source
Address, and Source Port.
8. Click Then next to From.
9. In the Comment box, enter the comment.
10. From the Loss Priority list, select the packet loss priority (PLP)
level to set it as low, medium-low, medium-high, or high.
11. In the Forwarding Class box, enter the packet forwarding class
name.
Copyright © 2010, Juniper Networks, Inc.