Base Station; Optional Valve Actuators - Hayward OnCommand Installation Manual

Base Station

The AQL2-BASE-RF base station must be installed if the AQL2-SS-RF or AQL2-POD will be used. To install
the base station, remove the knockout on the upper left side of the OnCommand main control unit, insert the base
station, and then tighten the nut from the inside. Also refer to the Base Station installation manual and the diagram
on page 12.

Optional Valve Actuators

(included with ONCOM-ACT, ONCOM-ACT-RC)
For optional actuators used with the OnCommand—note that the internal cams in the actuator may also have to be
adjusted depending on the way the actuator is mounted on the valve and the desired valve action.
RETURN SUCTION
OUT OUT IN IN
IN
OUT
(Common) (Common)
3