Table of Contents
Advertisement
The show controllers e3 slot/port all command displays identical information for
an E3 controller (except where noted).
Output Filtering
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See Command Line Interface in
JUNOSe System Basics Configuration Guide.
baseline interface
show controllers e3
show controllers t3
T3 24-hour total counters Displays the cumulative counters for the last 24-hours
or since the interface was started
The last 24-hours of 15-minute reporting intervals (96 intervals)
Use to set a statistics baseline for serial interfaces.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the optional delta keyword with the show interfaces serial commands to
view the baseline statistics.
Example
host1#baseline interface serial 2/0
There is no no version.
See baseline interface.
Use to display the parameters and MIB statistics on an interface.
Use the brief keyword to display the administrative and operational status of all
configured T3 or E3 interfaces, or to display abbreviated information for the
specified T3 or E3 interface.
For definitions of the MIB statistics, see RFC 2496 Definitions of Managed
Objects for the DS3/E3 Interface Types (January 1999)
Field descriptions
Description Text description or alias if configured for the interface
ifAdminStatus One of the following administrative states of the interface:
ifAdminUp Interface is administratively enabled
ifAdminDown Interface is administratively disabled
ifAdminTesting Interface is administratively configured in a testing
state
Chapter 2: Configuring T3 and E3 Interfaces
Monitoring Interfaces
65
Advertisement
Table of Contents
