Table of Contents
Advertisement
JUNOSe 11.0.x Physical Layer Configuration Guide
4.
5.
6.
7.
8.
9.
Example 3: Configuring Frame Relay
The following example illustrates how to configure Frame Relay on VT 1/7/4 in path
2 of the configuration shown in Figure 11 on page 142.
1.
2.
3.
Example 4: Configuring PPP
The following example illustrates how to configure PPP on VT 1/2/2 in path 2 of the
configuration shown in Figure 11 on page 142.
1.
2.
144
Configuration Examples
host1(config-controller)#path 20 stm1 2
host1(config-controller)#path 30 stm1 3
host1(config-controller)#path 40 stm1 4
Configure a TU-12 on TUG-2 #7 on TUG-3 #2 of path 10.
host1(config-controller)#path 10 e1 2/7/1 tu12
Configure a TU-12 on TUG-2 #5 on TUG-3 #2 of path 10.
host1(config-controller)#path 10 e1 2/5/2 tu12
Configure a fractional E1 line on tributary 2/7/1 of path 10.
host1(config-controller)#path 10 e1 2/7/1 channel-group 1 timeslots 2-5
Configure an unframed E1 line on tributary 2/5/2 of path 10.
host1(config-controller)#path 10 e1 2/5/2 unframed
Configure a TU-12 on TUG-2 #4 on TUG-3 #1 of path 30.
host1(config-controller)#path 30 e1 1/4/1 tu12
Configure an unframed E1 line on tributary 1/4/1 of path 30.
host1(config-controller)#path 30 e1 1/4/1 unframed
Select the interface on which you want to configure Frame Relay.
host1(config)#interface serial 4/0:2/1/7/4/1
Specify Frame Relay as the encapsulation method on the interface.
host1(config-if)#encapsulation frame-relay ietf
Configure the interface as a DTE, DCE, or NNI.
host1(config-if)#frame-relay intf-type dce
Select the interface on which you want to configure PPP.
host1(config)#interface serial 4/0:2/1/2/2/1
Specify PPP as the encapsulation method on the interface.
Advertisement
Table of Contents
