Table of Contents
Advertisement
path ds1 fdl carrier
path ds1 fdl string
NOTE: The router sends these FDL messages only if you have issued the path ds1
fdl command with the ansi or all keyword and then issued the path ds1 fdl transmit
command.
path ds1 fdl transmit
Specify the keyword all to support both the ANSI and AT&T standards.
Specify the keyword none to remove the current FDL mode settings.
You can configure a different standard on each T1 channel.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl att
Use the no version to restore the default, none.
See path ds1 fdl.
Use to specify that an interface is used in the carrier environment.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl carrier
Use the no version to restore the default situation, in which the T1 interface does
not operate in the carrier environment.
See path ds1 fdl carrier.
Use to configure an FDL message as defined in the ANSI T1.403 specification.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl string eic "ERX-1440"
Use the no version to restore the default value to the specified FDL message or
to all FDL messages.
See path ds1 fdl string.
Use to configure the router to send the specified type of FDL message on the T1
channel.
By default, the router sends no FDL messages.
Chapter 4: Configuring Channelized OCx/STMx Interfaces
Configuration Tasks
129
Advertisement
Table of Contents
