Juniper JUNOSE 11.0.X PHYSICAL LAYER Configuration Manual page 56

JUNOSe 11.0.x Physical Layer Configuration Guide
34
Monitoring Interfaces
Description Text description or alias if configured for the interface
ifOperStatus Physical state of the interface:
ifOperDown Interface is not functioning
ifOperLowerLayerDown Lower layer in the interface stack is not
functioning
ifOperNotPresent Module has been removed from the chassis
ifOperTesting Interface is being tested
ifOperUp Interface is functioning
Yellow Alarm detection Status of yellow alarm detection: active or not
active
Yellow Alarm generation Status of yellow alarm generation: active or not
active
snmp trap link-status Status of SNMP trapping (enabled or disabled)
Framing Type of framing format
Clock source Type of clock source
Loopback state Type of loopback (if enabled) and status: enabled or disabled
Last remote loopback request sent None or deactivate
FDL Status of FDL: standard configured or not configured
FDL Transmit Path Status of path transmission: active or not active
FDL Transmit Idle-Signal Status of idle signal: active or not active
FDL Transmit Test-Signal Status of test signal: active or not active
Equipment Identification Code eic string for FDL
Line Identification Code lic string for FDL
Frame Identification Code fic string for FDL
Unit Identification Code unit string for FDL
Facility Identification Code pfi string for FDL
Port Code port string for FDL
Generator Number generator string for FDL
BERT test Number of current test and total number of tests
Test interval Length of the BERT test
status Sync (controller is synchronized with remote device) or NoSync
(controller is not synchronized with remote device)