Juniper JUNOSE 11.0.X PHYSICAL LAYER Configuration Manual page 60

JUNOSe 11.0.x Physical Layer Configuration Guide
show controllers t3 remote
38
Monitoring Interfaces
snmp trap link-status of SNMP trapping (enabled or disabled)
Ds0 time slot map Fractional T1 subchannel
Ds0 mode Base data rate: either Nx56 or Nx64
The ft1 option displays the state of the serial interface.
The optional slot and port parameters display information about a specific slot
and port.
Example
host1#show controllers t3 ft1
Ft1 Interface at 2/0:1/1
Description: toronto ft1 interface
ifOperStatus = ifOperLowerLayerDown
snmp trap link-status = disabled
Ds0 time slot map = 0x1
Ds0 mode = Nx64
See show controllers t3.
Use to display MIB statistics for the remote end of a channelized T3 interface
configured for MDL or for the remote end of a T1 channel configured for FDL.
Specify the all option to display detailed information for all 15-minute intervals.
For definitions of the MIB statistics for a T3 interface, see RFC 2496 Definitions
of Managed Objects for the DS3/E3 Interface Types (January 1999).
For definitions of the MIB statistics for a T1 channel, see RFC 2495 Definitions
of Managed Objects for the DS1, E1, DS2 and E2 Interface Types (January 1999).
Field descriptions for a T3 interface
Far End MDL Carrier bit Status of MDL configuration on remote device
connected to T3 interface
set MDL is configured for carrier mode
not set MDL is not configured for carrier mode
Far End Equipment Identification Code eic string sent by remote device
for MDL
Far End Line Identification Code lic string sent by remote device for MDL
Far End Frame Identification Code fic string sent by remote device for MDL
Far End Unit Identification Code unit string sent by remote device for MDL
Far End Facility Identification Code pfi string sent by remote device for
MDL
Far End Generator Number generator string sent by remote device for MDL
Far End Port Number port string sent by remote device for MDL