Juniper JUNOSE 11.0.X PHYSICAL LAYER Configuration Manual page 235

downstream devices. Reports statistics in bytes in cells and accounts
for cell encapsulation and padding overhead.
none Shaping mode is not configured
Operational qos-shaping-mode Actual shaping mode for the interface:
disabled
frame
cell
none
queue Hardware packet queue associated with the specified traffic class
and interface
traffic class Name of traffic class
bound to Interface to which queue is bound
Queue length Length of the queue, in bytes
Forwarded packets, bytes Number of packets and bytes that were
forwarded on this queue
Dropped committed packets, bytes Number of committed packets and
bytes that were dropped
Dropped conformed packets, bytes Number of conformed packets and
bytes that were dropped
Dropped exceeded packets, bytes Number of exceeded packets and
bytes that were dropped
Example Displays the status of a Gigabit Ethernet interface
host1#show interfaces gigabitEthernet 1/0
GigabitEthernet2/0 is Up, Administrative status is Up
Hardware is SEEQ 8101, address is 0090.1a01.056f
Primary MAU is 1000BASE-SX, secondary MAU is SFP (Empty)
MTU: Operational 1518, Administrative 1518
Duplex Mode: Operational Full Duplex, Administrative Auto Negotiate
Speed: Operational 1000 Mbps, Administrative Auto Negotiate
Debounce: State is Disabled
Clear arp: State is Enabled
Link: Operational Primary Link Selected,
Administrative Link Selected Automatically
Link Failover Timeout: Operational 319 ms, Administrative default
Primary link selected 1 time, Secondary link selected 0 times
Primary link signal detected, Secondary link signal not detected
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 0, Unicast 0
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Chapter 5: Configuring Ethernet Interfaces
Monitoring Ethernet Interfaces
213