JunosE 11.0.2 Release Notes
Errata
60
Errata
This section identifies errors found in the JunosE documentation. These errors are
corrected in subsequent releases of the affected documentation.
The Obtaining Documentation section in the About the Documentation chapter of
every JunosE document erroneously indicates that MIBs are available on the
JunosE Software CDs. MIBs are available for a particular software release only
from the software image bundle that is available for download from the Juniper
Networks website. We are no longer providing software CDs beginning with
JunosE Release 11.0.0.
The JunosE documentation for Release 6.0.5 and higher-numbered releases
states that when you upgrade the JunosE Software from Release 5.1.1 or
lower-numbered releases, you must perform the upgrade in two stages: first to
an intermediate release and then to the higher-numbered release that you want
to run. This statement is only partially correct; you must perform a two-stage
upgrade only when you upgrade from a new NVS card. This restriction is not
applicable if you upgrade your software remotely through Telnet or FTP.
The imprecise information appears in the following JunosE documents:
The Upgrading to JunosE Software Release 6.x.x or Higher-Numbered Releases
from Release 5.1.1 or Lower-Numbered Releases special hardware notice
dated 31 March 2006
The Upgrading to JunosE Software Release 6.x.x or Higher-Numbered Releases
from Release 5.1.1 or Lower-Numbered Releases section in the JunosE
Release Notes for the following releases:
Releases 6.0.5, 6.1.4, and 6.1.5
Releases 7.1.2, 7.1.3, 7.1.4, 7.2.x, 7.3.x
Releases 8.x, 9.x, 10.x, 11.0.x, and 11.1.x
The Upgrading to JunosE Software Release 6.x.x or Higher-Numbered Releases
from Release 5.1.1 or Lower-Numbered Releases section in ERX Hardware
Guide, Chapter 8, Maintaining ERX Routers for the following releases:
Release 7.3.x
Releases 8.x, 9.x, 10.x, 11.0.x, and 11.1.x
The Upgrading to JunosE Software Release 6.x.x or Higher-Numbered Releases
from Release 5.1.1 or Lower-Numbered Releases section in the JunosE System
Basics Configuration Guide, Chapter 3, Installing JunosE Software for the
following releases:
Release 7.3.x
Releases 8.x, 9.x, 10.x, 11.0.x, and 11.1.x
Need help?
Do you have a question about the JUNOSE 11.0.2 - RELEASE NOTES and is the answer not in the manual?
Questions and answers