Bfd; Cli; Dhcp - Juniper JUNOSE 11.0.2 - RELEASE NOTES Release Note

JunosE 11.0.2 Release Notes

BFD

CLI

DHCP

40
Known Problems and Limitations
After you have shut down the interface to the next hop (for the route that is
used to establish the BFD session), output for the show bfd session command
erroneously indicates the shutdown interface as Management Interface
(FastEthernet 6/0). [Defect ID 174271]
When you issue a run show ppp command, the CLI changes the configuration
level of the command line to Global Configuration mode rather than remaining
at the level from which you issued the command. [Defect ID 52165]
Work-around: Reissue the commands necessary to reenter the desired mode.
The logout subscribers all command may not log out all of the DHCP
subscribers. Although the bindings and DHCP addresses are cleared, the show
subscribers summary command may display some of the DHCP subscribers.
[Defect ID 180176]
Work-around: Try using the dhcp delete-binding all command. If this does
not clear the subscribers, you may want to reload the line module to avoid
further issues.
DHCP packets are not forwarded to the DHCP server over dynamically created
interfaces when all of the following are true: [Defect ID 180343]
DHCP relay or DHCP relay proxy is configured on the router.
The client-facing interfaces are created dynamically using bridged Ethernet
over static ATM PVCs.
The ip auto-detect ip-subscriber command is configured to enable packet
detection (packet triggering) and to trigger creation of dynamic subscriber
interfaces.
Work-around: To avoid this defect, do all of the following:
Do not use the ip auto-detect ip-subscriber command to enable packet
triggering and to create dynamic subscriber interfaces
Ensure that DHCP external server is configured in the virtual router.
Ensure that the set dhcp relay inhibit-access-route-creation command is
configured in the virtual router to prevent DHCP relay from installing host
routes by default.