Juniper JUNOSE 11.0.2 - RELEASE NOTES Release Note page 74

JunosE 11.0.2 Release Notes
66
Errata
Use the ip-router-name command in Domain Map Configuration mode to
assign an IPv4 virtual router. The no version restores the default router. An
example of the ip-router-name command is as follows:
host1(config)#aaa domain-map xyz.com
host1(config-domain-map)#ip-router-name ipv4vr
NOTE: The ip-router-name command replaces the router-name command,
which has been deprecated and may be removed completely in a future release.
JunosE Broadband Access Configuration Guide, Chapter 2, Monitoring and
Troubleshooting Remote Access, fails to include the following information for the
output of the show radius servers command:
If a RADIUS server was never configured on the virtual router, the command
displays the following message:
host1#show radius servers
no radius servers configured
If a RADIUS server was configured previously and then removed on the virtual
router, the command displays the following information:
host1#show radius servers
RADIUS Authentication Configuration
-----------------------------------
Monitoring RADIUS Server Information ¦ 1
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Accounting Configuration
-------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Pre-Authentication Configuration
---------------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
RADIUS Route-Download Configuration
-----------------------------------
Udp Retry Maximum Dead
IP Address Port Count Timeout Sessions Time Secret Status
------------- ---- ----- ------- -------- ---- ------ ------
In the JunosE documentation for Release 9.3.x, 10.x.x, and 11.0.x, the
descriptions about support for DSL line rate information retrieval from access
nodes for transmission to the SRC software, and the sscc
update-policy-request enable command introduced by this feature are
erroneously omitted. This feature was introduced in JunosE Release 9.3.0.