Table of Contents
Advertisement
Errata
Copyright © 2010, Juniper Networks, Inc.
This section identifies errors found in the JunosE documentation. These errors are
corrected in subsequent releases of the affected documentation.
The Resolved Known Problems section of the JunosE 10.2.2 Release Notes failed to
mention in the IP section that defect ID 90081, High CPU utilization, was fixed in that
release.
In JunosE Physical Layer Configuration Guide, the Monitoring SONET/SDH Interfaces
section in Chapter 3, Configuring Unchannelized OCx/STMx Interfaces, and the
Monitoring Interfaces section in Chapter 4, Configuring Channelized OCx/STMx
Interfaces, for JunosE Release 9.x, Release 10.x, Release 11.0.x, Release 11.1.x, and
Release 11.2.x, the field description of the "time since last status change" field is
incorrectly displayed as "time since the module was rebooted" for the show
controllers sonet and show controllers sonet configuration commands.
The correct field description is "time the controller has been in the current physical
state" for all four instances.
The following information was erroneously omitted from the Generating UDP
Checksums in Packets to L2TP Peers section of Chapter 12, Configuring an L2TP LAC, of
the JunosE Broadband Access Configuration Guide for Release 11.1.x and Release 11.2.x:
L2TP checksum generation support is available on an ES2 10G Uplink LM and an ES2
4G LM only. It is not supported on an ES2 10G LM and an ES2 10G ADV LM. If an ES2
10G LM or an ES2 10G ADV LM is present when L2TP checksum is enabled, the
checksum is not calculated and its value is set to zero.
Release 11.3.0
Errata
57
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - RELEASE NOTES 2010-11-09 and is the answer not in the manual?