Ipsec; Ipv6; L2Tp; Mpls - Juniper JUNOSE 11.0.2 - RELEASE NOTES Release Note

JunosE 11.0.2 Release Notes

IPSec

IPv6

L2TP

MPLS

Multicast

OSPF

58
Resolved Known Problems
IPSec with NAT reports inboundSa = invalidAlgorithm when show ipsec
tunnel detail command is used. [Defect ID 90642]
IPv6 ND over dynamic interface does not work on ERX if it acts as LNS. [Defect
ID 88378]
ERX does not respond to L2TP control packet during ISSU. [Defect ID 90336]
SRP reset type: processor exception 0x68616c74 (halt) task: ip_Ctrl_2 with
continuous SNMP polling. [Defect ID 90472]
A new L2TP session cannot be established when the tunnel
controlChannel.congestionWindow size reaches 32768. [Defect ID 90864]
LM10U reset type panic file: aptationLayer.cc line: 3159
Hw2MplsAdaptationLayer::setEgressDirectNextHopLabel [Defect ID 90732]
LDP and OSPF flap when an unconfigured LM10 is reloaded with 75k MPLS
next hops. [Defect ID 90471]
The following commands, which appear in IPv6 PIM Data MDT Configuration
mode, have never been supported and have been removed from IPv6 PIM Data
MDT Configuration mode:
ipv6 pim data-mdt
ipv6 pim join-filter
ipv6 pim query-interval
mdt-data-delay
mdt-data-holdown
IPv6 PIM Data MDT Configuration mode has also been removed from the CLI.
[Defect ID 83791]
After executing the clear ipv6 ospf process command, interfaces in the DOWN
state appear in the show ipv6 ospf database output. [Defect ID 90478]
BNGSTL:11-0-0b1-5 reset type: exception 0x300 (data access: protection
violation (read attempt)) task: ospf_msgQueue_14. [Defect ID 185096]
mdt-data-timeout
route map
show ipv6 pim data-mdt
tunnel group-address-pool
tunnel source