System Maximums
Unsupported Features
The JunosE Release 11.0.x documentation set describes some features that are
present in the code but that have not yet been fully qualified by Juniper Networks.
If you use any of these features before they have been fully qualified, it is your
responsibility to ensure that the feature operates correctly in your targeted
configuration.
The following features are present but unsupported in this release.
E120 Router and E320 Router
Policy Management
The following commands have been enhanced to support this feature:
ipv6 http redirectUrl
In the current release, this feature is available for early field test purposes only.
Increased Number of Service Sessions and Subscriber Sessions for E120 and
E320 Routers
Beginning with JunosE Release 11.0.0, the maximum number of service
sessions and subscriber sessions that are supported per chassis for the Service
Manager application on E120 and E320 routers are as follows:
Number of Service and Subscriber
Sessions per Chassis for Service
Manager
Service sessions (active)
Active subscriber sessions
In the current release, this feature is available for early field test purposes only.
The ES2 10G LM and ES2 10G Uplink LM do not support layer 2 statistics for
VLANs.
Subscriber Interfaces on the ES2 10G Uplink LM
You can configure dynamic subscriber interfaces and static subscriber
interfaces on the ES2 10G Uplink LM using the CLI. However, configuring
subscriber interfaces on the ES2 10G Uplink LM provides no benefit because
access features such as per-subscriber QoS are unavailable on the module.
External Parent Groups Unsupported on ES2 10G, ES2 10G Uplink, and ES2
10G ADV LMs
External parent groups are not supported on the ES2 10G, ES2 10G Uplink, and
ES2 10G ADV LMs. If you create a policy that references an external parent
group on these LMs, the system prevents you from attaching it to the LM
interface and you receive an error message.
show profile
E120 Limits
E320 Limits
196,608
262,144
64,000
96,000
Release 11.0.2
9
Unsupported Features
Need help?
Do you have a question about the JUNOSE 11.0.2 - RELEASE NOTES and is the answer not in the manual?
Questions and answers