Ipv6; System Maximums - Juniper JUNOSE SOFTWARE 11.0.1 - RELEASE NOTES 7-14-2010 Release Note

IPv6

System Maximums

host1(config)#no ip dhcp-local limit pos
To display the maximum number of IP address leases available for POS access
interfaces, use the existing show ip dhcp-local limits command. For example:
host1#show ip dhcp-local limits
*****************************************
DHCP Local Server Address Limits
ATM Limit - 48000
VLAN Limit - 48000
POS Limit - 1000
Ethernet Limit - 48000
Support for Configuring IPv6 HTTP Redirect URL from Profile Configuration
Mode
You can now provide initial provisioning and service selection for the
subscriber, by using the IPv6 HTTP redirect URL feature. You use the ipv6 http
redirectUrl command from the Profile Configuration mode to specify the URL
to which a subscriber's initial Web browser session is redirected, as shown in
this example:
host1(config)# profile guidEnt6
host1(config-profile) # ipv6 http redirectUrl http://ispite.redirect.com
The following commands have been enhanced to support this feature:
ipv6 http redirectUrl
In the current release, this feature is available for early field test purposes only.
Increased Number of Service Sessions and Subscriber Sessions for E120 and
E320 Routers
Beginning with JUNOSe Release 11.0.0, the maximum number of service
sessions and subscriber sessions that are supported per chassis for the Service
Manager application on E120 and E320 routers are as follows:
Number of Service and Subscriber
Sessions per Chassis for Service
Manager
Service sessions (active)
Active subscriber sessions
In the current release, this feature is available for early field test purposes only.
show profile
E120 Limits E320 Limits
196,608 262,144
64,000 96,000
Release 11.0.1
9
Early Field Trial Features