Appendix A System Maximums; Appendix A, System Maximums - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - RELEASE NOTES 2010-11-09 Release Note

Appendix A
System Maximums
Copyright © 2010, Juniper Networks, Inc.
This appendix presents current system maximums for various E Series hardware
configurations. An E Series router does not simultaneously support all maximum
configurations.
For some entries, early field trial (EFT) values are presented in addition to supported
values. These values have not been fully qualified by Juniper Networks and are
mentioned only for field test purposes in this release. EFT values are enclosed within
parentheses with an EFT designation; for example, (96,000 EFT).
Modules referred to in the tables are identified by their physical label. For module
specifications, including their identifying labels, see ERX Module Guide, Table 1, Module
Combinations and E120 and E320 Module Guide, Table 1, Modules and IOAs.
System Maximums for ERX310,
ERX7xx, and ERX14xx
General router values
Physical layer values
Link layer values
Routing protocol and performance values
Policy and QoS values
Tunneling values
Subscriber management values
System Maximums for E120 and E320
Routers
General router values
Physical layer values
Link layer values
Routing protocol and performance values
Policy and QoS values
Tunneling values
Subscriber management values
Section
General System Maximums on page 60
Physical and Logical Density Maximums on page 61
Link Layer Maximums on page 64
Routing Protocol Maximums on page 69
Policy and QoS Maximums on page 72
Tunneling Maximums on page 74
Subscriber Management Maximums on page 76
Section
General System Maximums on page 78
Physical and Logical Density Maximums on page 79
Link Layer Maximums on page 81
Routing Protocol Maximums on page 87
Policy and QoS Maximums on page 90
Tunneling Maximums on page 94
Subscriber Management Maximums on page 96
59