Auto Diagnostics - Kurzweil KME61 - REV A User Manual

TEST MIDI PORT
TEST OK
If there was an error, the display would instead show:
TEST MIDI PORT
TEST FAIL CODE:00
In either case, the left soft button may be pressed to run the same test again or a different test
selected with the + and - buttons. As usual, the up and down buttons pressed together
will exit back to the Main Diagnostic Menu page.

AUTO Diagnostics

If AUTO is selected in the Engine Diagnostic Menu, all of the above diagnostics including the
sinewave are run in sequence repeatedly until stopped. Please turn down or disconnect
your audio system before selecting! Each iteration takes about 90 seconds. This mode is
useful for "burning in" a unit at the factory or after a repair has been made. Note that a
MIDI cable must be connected from MIDI Out to MIDI In for the MIDI test to pass.
If a test fails, the sequence will pause for a couple of seconds so the failure message can be
seen, then it will continue. A Fail Counter is displayed in the upper right corner of the
screen which increments every time a test fails.
To stop the test sequence, press and hold the up and down
recognized between the tests.
Troubleshooting
buttons until they are
7-9