System Hard Reset - Kurzweil KME61 - REV A User Manual

the next screen:
Waiting for data...
You should now start playing a previously recorded memory send from your sequencer
program. If you wish to cancel, press the right soft button to return to the "Receive memory
data" page.
displayed:
Receiving...
█ █ █ █ █
The bottom line is used to display a progress bar. When receiving is complete, the "Receive
memory data" page is displayed again. Although not shown, the right soft button will still
cancel receiving but the partially loaded memory may be corrupt.

System Hard Reset

This page allows you to erase all of the edits and changes you have made to your KME61 and
thus reset it to its original condition. This is a serious operation which is deliberately made
difficult as a data safety measure.
System Reset
To begin the reset process, press the right soft button labeled Reset which will display the
following screen:
ERASE EVERYTHING?
Yes
The right soft button will cancel the operation and return to the "System reset" page without
erasing anything. The left soft button will proceed to the next screen.
ARE YOU SURE?
The middle soft button will proceed with resetting to the factory defaults and the next screen.
The right soft button will cancel back to the "System reset" screen.
Defaults restored.
After the original factory defaults are restored, this screen is displayed briefly then returns to
Master Tune page which is the first page of Master mode.
Cancel
Otherwise once the first valid data block is received, the next screen is
Reset
Cancel
Yes Cancel
Master Mode
6-3