Lcd Diagnostic - Kurzweil KME61 - REV A User Manual

Switch Pedal
If a Kurzweil switch pedal is plugged into the SW Pedal jack, the display should change to
this after the pedal is stepped on once:
SWITCH PEDAL
VALUE 0
The value with be 0 when the pedal is not stepped on and 127 when it is stepped on. Note
that other brands of pedals may work backward: 127 when not stepped on and 0 when
stepped on. The KME61 will work with either type as long as it is plugged in before power
is switched on.
Panel Buttons and LEDs
Pressing any panel button will change the display to show button and LED information.
For example, pressing the Program Mode button will change the display to this:
PROGRAM MENU BUTTON
PROGRAM LED ON
The LED in the Program Mode button should also turn on. All of the non-sound select
buttons with LEDs will behave similarly.
Pressing a button without an LED, like up or down menu or + or - will display the button's
name but the bottom line will be blank since there is no associated LED.
Pressing a Group or Program button is a little different. For example, pressing the Piano
Group button will change the display to this:
EXTENSION KEY
POS:01-01 LED:RED
The top line will be the same for any of these buttons. The bottom line indicates the button's
row number first (01, 02, or 03) then the column number (01 - 08). Also the button's LED
should light. For the Program buttons, the LED color indication should match the LED that
is lit. To change from red to green or green to red, press the same Program button twice.
You can turn all of the LEDs on by pressing the + and - buttons together. The 8 Program
button LEDs should be orange and the others red. Press any other button to turn the LEDs
off again.
To escape the Scan diagnostics, press the up and down buttons together.
Diagnostic Menu page will now be displayed.

LCD Diagnostic

On the Main Diagnostic Menu, press the center soft button to start the LCD diagnostic.
While the diagnostic is running, the screen will turn white, then black, then will run through
all of the possible display characters. Let it run through 2 or 3 cycles of this to ensure there
are no problems then press and hold the up and down buttons until the main menu page is
displayed again.
Troubleshooting
The Main
7-7